Offline mode?

Discussion in 'Lasershow Designer QuickShow' started by Larry, Oct 11, 2017.

  1. Larry

    Larry Active Member

    Is there anyway to open the new version 3.0 with no hardware, I want to build my show and edit the cues at home then load the show on site, I used to do this in 2.0 but not sure I can now,
     
    minhky likes this.
  2. epyn

    epyn Member

    You can use offline the 3.0 version
    If you have a fresh installed QS3 you have to connect your hardware at first to ensure operating the software This used to be with the older versions of QS as well
     
    minhky likes this.
  3. Bob@Pangolin

    Bob@Pangolin Staff Member

    Please read the license agreement of QuickShow. There everything is defined why and how.

    Note: Often the com port changes when you change to another USB port on your device.
     
  4. lovin

    lovin Member

    I apologize for my English, I use a translator.
    I would like to use QS3 without hardware as I did with the QS2 version.
    How can this goal be achieved?
    Having the unnecessarily switched interface during the show work is not a good thing.
    I thank you in advance for the answer and the hope of a solution.
     
  5. Bob@Pangolin

    Bob@Pangolin Staff Member

    The software is provided with the hardware, so every once in a while (also after a new installation) you will need to connect the controller.
     
    minhky likes this.

Share This Page