soup@LIAstudios.com
New Member
For some reason I can't figure out my X axis has been constrained to the very bottom of the output. If i make a shape it goes over the entire output, and a few of the pages do such as the preset one of cowboys dancing and things like that. However resetting everything I can find has not changed this master X axis, I even installed a new update of the software and loaded and old workspace. The photos below show the error with the issue on the bottom and a line i created above it going over the entire output. The two photos after that show the most obvious places in the software to reset things and shows that everything is reset.
thanks so much for the help!
thanks so much for the help!