Problem with Y axis with FB3-QS

Discussion in 'FB series of products' started by Valpin, Sep 14, 2012.

  1. Valpin

    Valpin New Member

    Hi to all !

    I just got my LAYU A1000RGB+ and QuickShow software with FB3-QS scanner.

    Here is the problem I Have !

    - If I let the laser run the included graphics, I will work without any problem.
    - If I connect my FB3 to my laser and run anything from quickshow, It will run ok for more or less 30 seconds and then the Y axis collapse and the laser project only an horizontal line.

    Did any one had seen this problem before? :confused:
     
  2. aricha

    aricha Well-Known Member

    settings - projector settings
    scan rate to 18,000 pps
    size to 50%
    and see if there is a difference
     
  3. Valpin

    Valpin New Member

    It looks like my problem was with the laser unit after all. I have expecting some replacement PCBs from LAYU.

    I kept you posted ...%)
     

Share This Page