Projector set up

Discussion in 'Lasershow Designer 2000' started by Bang, May 25, 2011.

  1. Bang

    Bang New Member

    I'm having problems setting up a RGB diode projector on LSD2000.
    It's scanning but I have no blanking or color control.
    I've tried projector settings/color blank shift etc. but it doesn't seem to affect it.
     
  2. lasero2000

    lasero2000 Member

    rgb setup

    hi bang,

    i also have difficulties when using LSD 2000 -- the fix seems so be to use LD 2000 :)

    but seriously--try working your way through the 'palette' / 'Make New Palette Wizard'. i think that will fix your problem....

    if not you should make sure that your D25 ILDA control cable is not missing connections from pin3-pin3, pin16-pin16, pin5-pin5 and pin18-pin18. [and also that your laser modulation input does not require a shunt resistor to operate correctly....]

    hope this helps...

    lasero2000
     
  3. Bang

    Bang New Member

    Thanks for the help, I'll try to keep my typing fingers off the drugs :sillylol:. Turned out to be the cable and it's humming now
     

Share This Page