Qs starting set up question

Discussion in 'Lasershow Designer QuickShow' started by carlettodj, Jul 19, 2011.

  1. carlettodj

    carlettodj Active Member

    Hi,
    I have to drive four lasers with quickshow. now I have only one interface and i go in a ilda splitter for drive 4 lasers.
    Lasers are one only green, one only blu, and two rgy.
    In set up option of quickshow which section I must select?

    single color laser
    two color laser
    rgb
    rgbv

    I supposed two color lasers... that's right?
    Thanks Carlo
     
  2. Cyberb0b

    Cyberb0b Well-Known Member

    Yes, which makes that the single color lasers, only display a part of the information.

    However. it could be that the blue laser does not output at all.

    This is determened by wich ilda pin is used on the laser to control blue.
     

Share This Page