Question and Help Needed please

CarnageHHohio

CarnageHHohio

Member
Hi everyone. a beginner here with some "older" gear; (X-aser Mobile-Beat, FB3 interface). I am having issues with the beams if you will. They are not behaving ion the manner they should be as indicated on the preview square within the Quick-design software. Basically the laser patterns are not "fanning out" as they should...?
I will post a couple of pix and a link to a video showing the issue. I apologize as im sure its difficult to understand my specific problem as i don't yet know enough to properly describe it.
Update with media items coming soon, thanks in advance if you can assist!



- LJ Walter
Production Manager
Carnage Haunted House
3770 Refugee road. Columbus, Ohio. 43232-
www.CarnageHaunt.com

IMG_4620.PNG
Carnage Web Page
 
This could have multiple causes. It could be that your zone is not set correctly, that only the preview is wider. It could also be that the scanners cannot reach the angle you want them to make. Assuming you scan frames on 30k, the max throw angle is only 8 degrees. Would it be possible to post a picture of the results?
 
Hi Bob, thanks so much for the reply. This was one thing that had slipped my mind completely last week. I will get some media up ASAP. I’ve never set the “zones” with this laser or the software. Very well could be the issue. Once you see it, you can let me know specifically from there.
Thanks again for your assistance with this!

- LJ Walter
Production Manager
Carnage Haunted House
3770 Refugee road. Columbus, Ohio. 43232
www.CarnageHaunt.com


AF0A3D23-4CDA-45BA-B1B8-24C7C8F6EDD9.png
 
Bob@Pangolin said:
This could have multiple causes. It could be that your zone is not set correctly, that only the preview is wider. It could also be that the scanners cannot reach the angle you want them to make. Assuming you scan frames on 30k, the max throw angle is only 8 degrees. Would it be possible to post a picture of the results?
Click to expand...
Media: what preview shows vs what I see
 
You must log in or register to reply here.
Back
Top