Question Quick show pojector settings

Discussion in 'Lasershow Designer QuickShow' started by benji.h.blm, Nov 2, 2012.

  1. benji.h.blm

    benji.h.blm Member

    Is there a quick away to make a page of cues go to more than one FB3?
    so you don't have to do each cue individually
     
  2. smokeAndMirrors

    smokeAndMirrors Well-Known Member

    I don't think so. Best thing is to daisy-chain your ILDA connections with one FB3

    ie QS->FB3->P1->P2

    it's far quicker :)
     
  3. Bob@Pangolin

    [email protected] Staff Member

    You can route the cue's to multiple zones with your numeric keypad.

    Please open the help file and then search for "Controlling multiple lasers".
    That single page tells the whole story.
     
  4. vIQleS

    vIQleS Active Member

  5. benji.h.blm

    benji.h.blm Member

    thanks for the replies

    @ smokeAndMirrors - thanks but i would like a bit more control than that
    @ vIQleS - Thanks i have started to create cues like that

    But what is was meaning was is the a way when you got a page of cues

    you go:
    1. cue properties
    2. general (you then get a list of Zone with tick boxes)

    i want to be able to check say the first 2 zones for all the 60 cues on one page (is there a Quick way to do this ?)

    then i can route the cue's to either zone using numeric keypad
     

Share This Page