Discussion in 'Lasershow Designer 2000' started by LJ-Space, Feb 19, 2003.

  1. LJ-Space

    LJ-Space New Member

    I am interested in question if it is possible to use the Pangolin Lasershow2000 without the controller board install in the PC?
  2. Aaron@Pangolin

    Aaron@Pangolin Staff Member

    It is not possible to run LD2000 without the QM2000 board installed in your computer. This is because the LD2000 software actually runs on the board. :N
  3. Pangolin

    Pangolin Staff Member

    Actually there is one exception to what was written above. It is possible to run our software on a PC that does not have a QM2000 board installed, but only if you are using our network software and you have a QM2000 (or actually up to 20 QM2000 boards) located in a computer somewhere on the network. The network software works quite well and it is based on technology that we developed since 1997.

    Best regards,

    William Benner