L Lasermin New Member Dec 1, 2010 #1 I recently purchase QuickShow @& was setting up my projector but it is only doing about 2/3 of what it was before using a different program. In my color selector all my values are @ 100% but my voltages are not a full 5Vdc. Red 3.23 Green 3.19 Blue 2.47 Any ideas ????
I recently purchase QuickShow @& was setting up my projector but it is only doing about 2/3 of what it was before using a different program. In my color selector all my values are @ 100% but my voltages are not a full 5Vdc. Red 3.23 Green 3.19 Blue 2.47 Any ideas ????
L Lasermin New Member Dec 1, 2010 #2 I am running Analog when I disconnect the laser from the board & put 5Vdc direct I get twice the beam then with the controller. ???????
I am running Analog when I disconnect the laser from the board & put 5Vdc direct I get twice the beam then with the controller. ???????