QuickTimeline Tab is Gone

Discussion in 'Lasershow Designer QuickShow' started by Andrea Currano, Dec 3, 2018.

  1. Andrea Currano

    Andrea Currano New Member

    I finally upgraded to QuickShow 4.0 after successfully using QuickShow 3.0 for years. After going through the upgrade the Quick Timeline tab is missing at the bottom of the screen. Only the QuickText, QuickShape and QuickTrace tabs are showing - none of the other tabs. Any suggestions?
     
  2. Bob@Pangolin

    Bob@Pangolin Staff Member

    Please go though the setup wizard again, then schoose advanced or expert mode.