reverse X

Discussion in 'Lasershow Designer 2000' started by LjMrBubi, Mar 31, 2012.

  1. LjMrBubi

    LjMrBubi Well-Known Member

    Hi,how is possible reverse X with asteroids ?? :confused:
    Thanks and best regards M.Z.
     
  2. Aaron@Pangolin

    [email protected] Staff Member

    If the X axis is reversed all the time you should check the wiring of your projector or see if you can change it with a set of jumpers on your X scanner's amp.

    Otherwise you can change the X axis size to, "negative" the X size it currently is, in LD2000 under projector settings; make sure you save this to the the default settings in the LD2000.ini file on the last tab of the projector settings pop up box.
     
  3. LjMrBubi

    LjMrBubi Well-Known Member

    very thanks,best regards M.Z. :)
     

Share This Page