Set Number of simultaneous cue players in Flash?

Discussion in 'Lasershow Designer BEYOND' started by hitekvoop, Oct 14, 2015.

  1. hitekvoop

    hitekvoop Well-Known Member

    What if I want to flash play 8 cues simultaneously from APC40? In Flash mode, Multi-Cue set to 8/grid only 3 are allowed to play simultaneously. It's not a midi issue as I don't see midi off messages in monitor until I lift my fingers. Setting it to toggle will allow all 8 to play, but flash mode wont. Any place to change this behavior?
     
  2. Bob@Pangolin

    [email protected] Staff Member

    Open up the dynamics Tab at the right side of the screen and raise the limiters.
     
  3. hitekvoop

    hitekvoop Well-Known Member

    Fantastic. Thanks Bob!
     

Share This Page