Setting full power for a frame

Discussion in 'Lasershow Designer QuickShow' started by anderino, Jan 6, 2012.

  1. anderino

    anderino New Member

    I would like to know if QuickShow can increase the power of the output for certain frames. For example, if I set the global settings to 100% red, 80% Green and 50% blue so that I get a nice white, can I have certain frames/beam shows where all the lasers are on 100% full power?
     
  2. smokeAndMirrors

    smokeAndMirrors Well-Known Member

    Not as such.

    In the frame editor you can make points 100% bright by ctrl-clicking. Otherwise, you can't control the output in the way you describe. Pangolin have a lot of very clever stuff running under the hood for optimising brightness levels. They don't generally let you mess with it :)
     

Share This Page