Setting up: QS/LKPD2

R

revmutt

New Member
I'm sorry that my first post is probably a repeat of many first posts.
I am having trouble outputting a test or any image.
Blinky yellowish lights yes, ILDA red light lit on projector yes.

I am guessing this can be fixed either in the color settings or in the sizing and probably not anything to do with settings in the projector.
If anyone is using this combo please chime in.

Thanks,
Tommy
 
The FB3 should blink red, when laser output is enabled.
Only then its "Hot" and delivers output to the ilda connector.

Can you tell me which color the fb3 light is when you think it generates laser output?
 
Hi Bob. I'm going to give it anther go this afternoon. I have a feeling that I may be in better shape now that I have updated. I was receiving yellow which suggests it may have been troubled by the date.

Tommy
 
UPDATE:
The reason that the laser wasn't receiving any messages was resolved by installing the new version with the date correction.

My next battle is figuring out whether the projector needs to be reset because everything is upside down or if I just have to keep adjusting with the software.

I haven't quite figured out optimum settings for example:
1. Line graphics translate fine although I usually have to adjust the speed to slow things down.
2. some graphics which look 3D don't project that way, shading isn't happening.
3. Colors seems good except orange.

I have to say that despite the above mentioned bridges to cross I am going to say the software seems really good so far.

Thanks,
Tommy
 
You must log in or register to reply here.
Back
Top