SMPTE TimeCode

Discussion in 'Lasershow Designer 2000' started by Larry, Dec 19, 2004.

  1. Larry

    Larry Active Member

    I need to sync to a SMPTE signal from a Pyro company here. Wondering if anyone has done this and might be able to walk me through it (I know very little about SMPTE) and give me any advise on problems I might see. I noticed the TC2000 on the site outputs via the RS232 port. Do I load drivers for the device so Pangolins knows it is there or how do I set it up to recongnize the input.
    thanks
    Larry
     
  2. Pangolin

    Pangolin Staff Member

    Hi Larry,

    For the TC2000, you do not need drivers or anything else. It was designed specifically to work with Showtime and Autoplay. All you do is hook it up and it works. No fuss, no muss... :cool:

    Bill
     

Share This Page