Some advice please......

Discussion in 'Lasershow Designer QuickShow' started by Limelight68, Aug 7, 2012.

  1. Limelight68

    Limelight68 Member

    Hello everyone,

    I have recently moved into the area of band lighting for a local band i work with and have purchased several items including a KAM 1000 3D laser and the Pangolin Quickshow software which i am slowly learning my way about with.

    My question to you all is "what would be the best placing to use waves and the such like with a haze machine to create the most stunning effect without the danger of hurting anyone?"

    I have a truss that will go to a height of 4mtrs and can also fix the laser to the side poles if thats advisable?

    Any help or advise would be greatly appreciated.

    Many Thanks, Mark :)
     
  2. Aaron@Pangolin

    [email protected] Staff Member

    US regulations state your laser projection must be 3 meters from the highest point where an audience member might stand. I know you are not in the US, but by conforming to their... our regulations, you will be doing your best to be safe.

    I would say put your projector at the 4 meter height on the truss and try to keep your scan area limited to 1 meter below your projector height (should leave the bottom of your scan area 3 meters above your audience) and you should be good.
     

Share This Page