Targeted beams

Lubomir

Member
Hello,
new to QS. I am trying to make Targeted beams work but they just won't. I followed the official tutorial, got it all set up, but the laser (lw CS-2000RGB FX MK3) just won't output the beams. In just one case they show - when I enable at least 3 of them in the setup. But the QuickTargets panel doesn't do anything for me. All the other preset cues work fine. I must have my zones right I guess when I can, in that one case, output them. Thanks for any advice!
 
Some lasers have protection on board. It could be that you need to disable the scan fail on FB4 and / or in the settings of your laser (depending on the hardware you are using).
 
Back
Top