Timecode

Discussion in 'Lasershow Designer 2000' started by shiluxi, Oct 25, 2013.

  1. shiluxi

    shiluxi New Member

    Hello everyone!
    I know showtime2000 the TC2000 timecode can receive time code,
    It sends timecode do? How to send?
    thank you!
     
  2. Bob@Pangolin

    [email protected] Staff Member

    Hello,

    It can send as well.


    If you check the folder of LD2000 and execute the application TC2000.

    This application is able to write timecode.

    This application you can also find on the Pangolin show portal.



    Best regards,

    Bob
     
    Last edited by a moderator: Oct 25, 2013
  3. shiluxi

    shiluxi New Member

    Hello Bob,

    First, thank you very much,But I found a new problem,

    showtime2000 and TC2000 how it can not be synchronized playback?


    Best Regards,
    lucy shi
     
  4. Bob@Pangolin

    [email protected] Staff Member

    Hi Shiluxi,

    As far as my knowledge goes;

    you can use the timecode writer to write an tape with timecode (or an wav file)

    Then you can use ld2000 to read the timecode which is broadcasted to your an other machines..

    You can even use the Audio jack output from your laptop to play this timecode file.

    If you can't make it work, please contact us at support @ pangolin . com
     
  5. shiluxi

    shiluxi New Member

    Okay, thank you very much!
     
  6. aricha

    aricha Well-Known Member

    recording Time Code

    Hi Bob

    How can I recored a wav file with TC2000?

    When you press write TC it will send Time Code from the RCA Out of the TC2000. It dose not create a file.
     
  7. Bob@Pangolin

    [email protected] Staff Member

    The TC2000 cannot record an wav file.

    In this case; you need to connect an cable from the rca to the line-in (probably jack) of your pc. Then every application like for example Audacity can record the input of the pc.
     
  8. Aaron@Pangolin

    [email protected] Staff Member

    You can even use the generic Windows "Sound Recorder" to take the output of the TC2000 to make a timecode wave file by using a cable to go from the TC2000 write RCA output to your comptuer's line in input.
     

Share This Page