Triggiering LD2000 using a lighting consol

Discussion in 'Lasershow Designer BEYOND' started by tom10293, Sep 11, 2013.

  1. tom10293

    tom10293 New Member

    Hi there,

    I would like to know if its possible to control/trigger either LD2000 or BEYOND using a lighting console by DMX or Art-Net. The console in question is a MQ100Pro 2014 if that makes any difference.

    At the moment there are two protocols running the shows. The projectors are run using the Pangolin software but we have taken delivery of 70 10cell single diode battens. This is obviously very channel hungry and the best way to run these is through a console. These run off DMX and at the moment are having to hand control over to the LD running the show. We would like a way of running both from the same source, which is this case is the lighting consol. Is this possible? I've been scratching my head for ages!

    Hope this makes sense.
    Thanks,
    Tom
     
  2. Aaron@Pangolin

    [email protected] Staff Member

    Hey Tom; I am not sure if I understand what you want 100% but from what I think you are asking yes it should be possible. BEYOND takes ArtNET real easily for generic DMX control and you can access PangoScript from DMX/ArtNET to get more detailed control.
     

Share This Page