Two questions - frame editor

Discussion in 'Lasershow Designer QuickShow' started by Randomseed, Aug 26, 2013.

  1. Randomseed

    Randomseed Member

    1) How do you add a blanking point

    2) When you have multiple points stacked on top of each other (edge and point lets say) how do you select one or the other? They always both get selected for me no matter what I do.
     
  2. Aaron@Pangolin

    [email protected] Staff Member

    You use the add point function and click on the point before the spot you want to add it to and then drag the new point to that spot.

    It can be tricky, but if you zoom in as close as possible, you can click the top one, drag it a bit off to the side, then click the next one down, and go from there.
     
  3. Randomseed

    Randomseed Member


    ummm what?
     
  4. Aaron@Pangolin

    [email protected] Staff Member

    Use the "add point" tool "+" and click on the frame point directly before the exact spot you want to add an additional blanking point to. Make sure you have selected the black box next to the one you would select your point color (to make it a blanked point you are adding instead of a colored point).

    You are going to add the blanking point to the preceeding point, then drag it along to the spot to where you want the new blanked point at.
     

Share This Page