zone geometric correction

Discussion in 'Lasershow Designer BEYOND' started by joeglad77, Mar 26, 2019.

  1. joeglad77

    joeglad77 New Member

    Hi sir,
    may i know how to copy the below attached picture ( zone2 ) cue to geometric correction area,,
    This is our building area diagram to i shoot lasers,. So how can i bring up this look to zone geometric correction area to set zone,,.?
    Thanks in advance,.
     

    Attached Files:

  2. Bob@Pangolin

    Bob@Pangolin Staff Member

    You cannot bring the content of a cue into the zone editor.
    In this case you will need to setup the zones separately when you are actually working on the building.
     
  3. lorenzopompei

    lorenzopompei Active Member

    if you leave in output the frame and go to the geometric corrector you can correct the area by viewing the shape of the frame. that's what you need?
     
    Bob@Pangolin likes this.