zone geometric correction

[joeglad77]

Hi sir,
may i know how to copy the below attached picture ( zone2 ) cue to geometric correction area,,
This is our building area diagram to i shoot lasers,. So how can i bring up this look to zone geometric correction area to set zone,,.?
Thanks in advance,.

 

[Bob@Pangolin]

You cannot bring the content of a cue into the zone editor.
In this case you will need to setup the zones separately when you are actually working on the building.

 

[lorenzopompei]

if you leave in output the frame and go to the geometric corrector you can correct the area by viewing the shape of the frame. that's what you need?