Zones and live control

Discussion in 'Lasershow Designer BEYOND' started by smokeAndMirrors, May 8, 2014.

  1. smokeAndMirrors

    smokeAndMirrors Well-Known Member

    I am running a capture cue which outputs to 4 projectors. Each projector has its own zone. In the Live Control tab, I select the "only affect the selected zones" tab, then select 2 of the 4 zones. I then change the z rotation rate knob, but all the zones are affected, not just the selected ones. Is that the expected behaviour?
     
  2. ENOT

    ENOT Software Developer Staff Member

    Thanks for pointing on! This is problem of build 612. Newer version work correctly.

    Best Regards,

    Alexey.
     

Share This Page