Timecode out (artnet)

[Pim]

I get some problems with sending timecode out via Artnet.
Is there some good tutorial available for setting up Artnet Timecode out settings?

I've done some settings, but the timecode signal is not going out on artnet.

• • Beyond timecode out is setup to a network adapter
  • DMX output 1 is setup to Arnet
  • Timeline show is set on outgoing timecode
  • Ethernet adapter is set to manual IP address within the same range to the receiver unit

When I start the show, the timecode window stays red.
Any ideas what's going wrong here?

 

[Bob@Pangolin]

Have you tried to disable the firewalls?

 

[Pim]

Yes, all firewalls are disabled