BAM settings are not applied when playing FB4 exported cues from SD card

[JDKiM]

Hello everyone,


I am using BEYOND Advanced version 5.5.0.

In Project Settings, I configured BAM and set the brightness of a specific zone to 0%.

After that, I exported several cues to the projector's SD card using the FB4 Export function. During the export process, I made sure to include both BAM and Size settings.

However, when I trigger those exported cues from a DMX lighting console, the BAM settings that were configured in BEYOND are not applied. The area that should be at 0% brightness is still being displayed.

Could anyone explain why this is happening?

Is there an additional setting required on the FB4, the projector, or within BEYOND to make BAM work correctly when cues are played back from the SD card via DMX?

Any advice or suggestions would be greatly appreciated.

Thank you in advance.

 

[Bob@Pangolin]

I suspect this is something in the export procedure. This is functional and does not require any additional settings except for the obvious ones.
I assume you exported them as DMX workspace and not as timeline. Also you havre right-clicked the cues that you want to export and made sure that they are pointing tot the zone that has the bam defined? And that you disabled all the checkboxes on the zones advanced tab?