aricha
Well-Known Member
I have set graphics to projector 1& atmospherics to projector 2
I have a logo on projector 1 and a wave on projector 2
I want to change the atmospheric effect and let the logo stay forever
In a One Cue mode the laser images replace each other
And does not let me have a logo and a wave
In a Multi Cue the logo goes to projector 1 the wave to projector 2
But when I want to change to a different wave it adds it to the first wave and I have 2 waves projected
If I will change back to One cue mode – selecting a new wave is stopping the projection of the logo on projector one
I can press the first wave again so it will disappear
1 – Selecting the first wave and than the second wave – I get darkness
2 - Selecting the second wave and than the first wave – I get 2 wave
This way the transitions are not nice
Is there a way to do it right?
Thank you
I have a logo on projector 1 and a wave on projector 2
I want to change the atmospheric effect and let the logo stay forever
In a One Cue mode the laser images replace each other
And does not let me have a logo and a wave
In a Multi Cue the logo goes to projector 1 the wave to projector 2
But when I want to change to a different wave it adds it to the first wave and I have 2 waves projected
If I will change back to One cue mode – selecting a new wave is stopping the projection of the logo on projector one
I can press the first wave again so it will disappear
1 – Selecting the first wave and than the second wave – I get darkness
2 - Selecting the second wave and than the first wave – I get 2 wave
This way the transitions are not nice
Is there a way to do it right?
Thank you