Enntec Open?

Discussion in 'Lasershow Designer QuickShow' started by rodman1369, Apr 14, 2012.

  1. rodman1369

    rodman1369 Member

    Can one use an Enntec OPEN with QS? It sees the open...but the test does not work and cannot control a dms light. :confused:
     
  2. Aaron@Pangolin

    [email protected] Staff Member

    It is my understanding that QS will only work with the ENTTEC DMX USB Pro controller unit.
     
  3. rodman1369

    rodman1369 Member

    Thanks....darn!:eek:
     
  4. Koja

    Koja Beta Tester

    any plans to include Artnet-Support? That would make things much easier in many cases as most DMX desks and software outputs Artnet by now... no need for the external cabling...
     
  5. Aaron@Pangolin

    [email protected] Staff Member

    I know BEYOND will work with Artnet... or has Artnet support but I do not think QuickShow will. I'll have to research the questions in your other thread. ;)
     
  6. Koja

    Koja Beta Tester

    I know Beyond does have it and I will definitely buy it, but as I am planning to buy a bunch of FB3s, the functionality of QS2 is also of interest ;-)
     
  7. Stuka

    Stuka Well-Known Member

    If you have Beyond, you'll have everything QS2 does, and MUCH more -
    including simultaneous support for multiple FB3's and/or QM2K'S!! :D
     
  8. rodman1369

    rodman1369 Member

    Enttec Pro

    Well...I got me an Enttec Pro and it works with my QS perfectly. I run a couple Chauvet LED Pinspot 360s using dmx via QS at the same time using QS to run my Reke500RGB. Not pushing the system a lot at this time...If I expand my dmx usage...I'll probably add an independent controller board and use QS only for the laser. But it Does work! Thanks Pangolin!:cool:
     
  9. Cyberb0b

    Cyberb0b Well-Known Member

    Well.. did you try to place an dmx event under an cue?

    Then you can drag the cue on the timeline for usage while running a show.
     
  10. Koja

    Koja Beta Tester

    yes, but with multiple FB3s it might happen that you do 2 shows at the same time or rent out the beyond system and are stuck with QS2 for a another simple show during that time...
     
  11. Aaron@Pangolin

    [email protected] Staff Member

    Have you watched the QuickShow tutorials?

    http://www.pangolin.com/QS/downloadmenu/page35/page35.html

    Watching them is the best starting point you will get for both QuickShow and BEYOND as they both have a similar "feel" to me.
     
  12. Koja

    Koja Beta Tester

    I've watched the tutorials, yes. I was refering to the Artnet-Functionality a few posts earlier. sorry for the confusion.
     

Share This Page