Ludwig Haenlein
Member
Hi, i have a general question to FB4 and Artnet mode….
I´m owning four FB4 interfaces, used normally with Beyond - so no problems. Now i want to use a FB4 with preloaded cues via Artnet DMX protocol to use a laser projector a little bit like a light scanner. I have tried different lightning programs wich are working well with DMX4ALL Artnet interface, but i will not get any output with FB4.
Programs are Beyond (using Artnet DMX for room light and effects), PCDimmer and LumiDMX - all working fine. (What you can also see with Wireshark protocol analyzer)
What i can see on the FB4 is a fast blinking orange light, if the Artnet output on the selected universe is started. So it looks, that the FB4 will see the Artnet frames, but no reaction. I have tested FB3 mode and the FB4 39 Channel DMX profile assignment.
I can test every channel combination - no reaction and no red light on the FB4.
So the question - what i´m doing wrong, what is missing - or is it not possible to get the cues - saved on the SD memory card of the FB4 - outputted to a laser projector via this way?
Thanks and kind regards
Ludwig
I´m owning four FB4 interfaces, used normally with Beyond - so no problems. Now i want to use a FB4 with preloaded cues via Artnet DMX protocol to use a laser projector a little bit like a light scanner. I have tried different lightning programs wich are working well with DMX4ALL Artnet interface, but i will not get any output with FB4.
Programs are Beyond (using Artnet DMX for room light and effects), PCDimmer and LumiDMX - all working fine. (What you can also see with Wireshark protocol analyzer)
What i can see on the FB4 is a fast blinking orange light, if the Artnet output on the selected universe is started. So it looks, that the FB4 will see the Artnet frames, but no reaction. I have tested FB3 mode and the FB4 39 Channel DMX profile assignment.
I can test every channel combination - no reaction and no red light on the FB4.
So the question - what i´m doing wrong, what is missing - or is it not possible to get the cues - saved on the SD memory card of the FB4 - outputted to a laser projector via this way?
Thanks and kind regards
Ludwig