Laser Projector

Discussion in 'The Lounge' started by Vito Pittaluga, Sep 16, 2011.

  1. Vito Pittaluga

    Vito Pittaluga New Member

    I have this TTL laser diode projectors, do i have to setup my LD 2000 board At Lasershowdesigner or or just plug them an run the progran as it is?

    I did setup the program before, but for some reason i cant get a 100% brightness when i use the LD 200 board.
    thanks.
    Vito.
     
  2. aricha

    aricha Well-Known Member

    make a new color pallet
    meybe youll get it brighter
    different frames will give you different brightness
    more points gives a brighter image
     
    Last edited: Sep 18, 2011
  3. Vito Pittaluga

    Vito Pittaluga New Member

    I did create a new pallete, as a single color laser with fast blankin, then at i hit next, there are two straght lines one with a 100% the other at 50% and theres another line that is not visible at 0% when i move the last 0% line to the right, the third line becomes visible but i can see the diagonal lines conecting the horizontal lines(no blankin). if i save it like that i shut off the signal, but i keep locking a dot projected.

    Vito
     
  4. aricha

    aricha Well-Known Member

    Leave the third line on 0%
    Take the second line should be as bright as the first line
    But I take it to 80% or more and make it brighter than the first line
    To get more power
    It will effect on the fade in & out
    But who cares power is what we want
     
  5. Vito Pittaluga

    Vito Pittaluga New Member

    laser projector.

    Thankyou very much

    Vito
     

Share This Page