Laser Projector

V

Vito Pittaluga

New Member
I have this TTL laser diode projectors, do i have to setup my LD 2000 board At Lasershowdesigner or or just plug them an run the progran as it is?

I did setup the program before, but for some reason i cant get a 100% brightness when i use the LD 200 board.
thanks.
Vito.
 
make a new color pallet
meybe youll get it brighter
different frames will give you different brightness
more points gives a brighter image
 
Last edited:
I did create a new pallete, as a single color laser with fast blankin, then at i hit next, there are two straght lines one with a 100% the other at 50% and theres another line that is not visible at 0% when i move the last 0% line to the right, the third line becomes visible but i can see the diagonal lines conecting the horizontal lines(no blankin). if i save it like that i shut off the signal, but i keep locking a dot projected.

Vito
 
Leave the third line on 0%
Take the second line should be as bright as the first line
But I take it to 80% or more and make it brighter than the first line
To get more power
It will effect on the fade in & out
But who cares power is what we want
 
You must log in or register to reply here.
Back
Top