vIQleS
Active Member
I may need to update this when I'm in front of my gear later, but i'll try and explain it and maybe someone will know what I'm talking about.
I've been using QS for a few months on and off with 1x FB3. I've had no problem setting / changing the settings for it when I switch between my RGB 700mW and one or both of my Green 1000mW.
I've just purchased another RGB, and FB3, and I've been trying to run through the setup process - X, Y, size, scanrate etc.
What's happening is I can set the first one to whatever I need, but then the second one doesn't seem to be seperate from the first; when I switch to it, whatever I'm changing applies to the first one [As well? Instead? I need to check this. I think I was getting both at once]
I've been using QS for a few months on and off with 1x FB3. I've had no problem setting / changing the settings for it when I switch between my RGB 700mW and one or both of my Green 1000mW.
I've just purchased another RGB, and FB3, and I've been trying to run through the setup process - X, Y, size, scanrate etc.
What's happening is I can set the first one to whatever I need, but then the second one doesn't seem to be seperate from the first; when I switch to it, whatever I'm changing applies to the first one [As well? Instead? I need to check this. I think I was getting both at once]