bikeraper
Active Member
Hi,
I'm using Beyond 2.1 and suddenly i had a misterius fail. I connected 4 FB3 an then started to make the laser settings. Laser on on FB3 No.1...ok Laser 2 on FB3 No. 2...I switched it on with a test pattern, but Laser 1 startet. I tested Laser 3+4 on FB 3+4.... but always Laser on started.
I tried Quickshow.... it worked perfectly on QS.
I just realized, that this miracle only happens in the "Projektor setting". When I go to a cue and define another laser for this cue it works perfectly
Please help me
I'm using Beyond 2.1 and suddenly i had a misterius fail. I connected 4 FB3 an then started to make the laser settings. Laser on on FB3 No.1...ok Laser 2 on FB3 No. 2...I switched it on with a test pattern, but Laser 1 startet. I tested Laser 3+4 on FB 3+4.... but always Laser on started.
I tried Quickshow.... it worked perfectly on QS.
I just realized, that this miracle only happens in the "Projektor setting". When I go to a cue and define another laser for this cue it works perfectly
Please help me
Last edited: