Quick Show Problems

[Gee]

Hi all

I used Quick Show last night for the first time with my mobile setup

It all worked fine at the start, then as the night progressed it kept blurring, and sometimes going into the mode where it projects loads of images when I didn't ask it to. I turned the laser off and back on again then it worked fine. but after a while it did the same again

I was running it through the same laptop as I use to control ADJ MyDMX Software. Could this be a problem?

Also the two interfaces were side by side on my table. Could this cause the problem?

Gary

 

[Aaron@Pangolin]

What you are reporting is very odd; I am not sure I have heard of anything similar.

Using QS with another software like you did should also not make a difference or cause anything like that.

The best way to determine the issue will be if you can work to reproduce the issue I would like to see a few screen shots of the QS interface while this is occuring along with some video of the output of the laser projector/preview window. If you can do this, send them to me via email to my "screen name".com.