Hi all
I used Quick Show last night for the first time with my mobile setup
It all worked fine at the start, then as the night progressed it kept blurring, and sometimes going into the mode where it projects loads of images when I didn't ask it to. I turned the laser off and back on again then it worked fine. but after a while it did the same again
I was running it through the same laptop as I use to control ADJ MyDMX Software. Could this be a problem?
Also the two interfaces were side by side on my table. Could this cause the problem?
Gary
I used Quick Show last night for the first time with my mobile setup
It all worked fine at the start, then as the night progressed it kept blurring, and sometimes going into the mode where it projects loads of images when I didn't ask it to. I turned the laser off and back on again then it worked fine. but after a while it did the same again
I was running it through the same laptop as I use to control ADJ MyDMX Software. Could this be a problem?
Also the two interfaces were side by side on my table. Could this cause the problem?
Gary