Hi, we have a system using Quickshow to control a Tarm 5, plus a Enttec DMX output device connected to a couple of blinders.
We have pre programmed some shows to music using the quick timeline, and loaded them as cues so the Dj can run them in his sets every so often.
Problem we have, is that he can preview the track by clicking on the cue while the laser output is disabled, allowing him to check how the track starts without the laser going off. But the DMX output still works. So the blinders will go off when he previews the tracks.
Is there any way of making it so that when the laser output is disabled, the DMX output is also disabled?
We have pre programmed some shows to music using the quick timeline, and loaded them as cues so the Dj can run them in his sets every so often.
Problem we have, is that he can preview the track by clicking on the cue while the laser output is disabled, allowing him to check how the track starts without the laser going off. But the DMX output still works. So the blinders will go off when he previews the tracks.
Is there any way of making it so that when the laser output is disabled, the DMX output is also disabled?