Synthetic image - layer mask ?

Discussion in 'Lasershow Designer BEYOND' started by zerowaitstate, May 23, 2017.

  1. zerowaitstate

    zerowaitstate Active Member

    Not sure if this is the correct terminology.

    What i would like to do is create a cue where shape act as a mask, only allowing other layers to be displayed inside its shape, or conversely other layers run underneath the specific shape.

    how is this achieved?

    Thanks in advance for the advise
     
  2. Bob@Pangolin

    [email protected] Staff Member

  3. zerowaitstate

    zerowaitstate Active Member

    Exactly what i was after, i was hoping i could do this with in the synthetic image creation but time line will get me to the desired goal, thanks for the heads up
     

Share This Page