Pim
New Member
I get some problems with sending timecode out via Artnet.
Is there some good tutorial available for setting up Artnet Timecode out settings?
I've done some settings, but the timecode signal is not going out on artnet.
When I start the show, the timecode window stays red.
Any ideas what's going wrong here?
Is there some good tutorial available for setting up Artnet Timecode out settings?
I've done some settings, but the timecode signal is not going out on artnet.
- Beyond timecode out is setup to a network adapter
- DMX output 1 is setup to Arnet
- Timeline show is set on outgoing timecode
- Ethernet adapter is set to manual IP address within the same range to the receiver unit
When I start the show, the timecode window stays red.
Any ideas what's going wrong here?