Laser Dude
Member
Hello,
I have noticed when I run a frame with a very slow scan rate so the beam steps each point, I can not imediately stop scanning it by reset or frame zero. It will continue to scan until the frame is finished.
Is there a way to interrupt the frame in mid scan once the QM2000 has started plotting the points in the frame?
I'm not looking for emergency stop, but a way to instantly move to another cue or reset.
Thanks,
Eric
I have noticed when I run a frame with a very slow scan rate so the beam steps each point, I can not imediately stop scanning it by reset or frame zero. It will continue to scan until the frame is finished.
Is there a way to interrupt the frame in mid scan once the QM2000 has started plotting the points in the frame?
I'm not looking for emergency stop, but a way to instantly move to another cue or reset.
Thanks,
Eric