Sol_Barnes
Member
Hey, hope you are all keeping well.
I'm looking for information on how many FB3s, FB4s and midi devices I can run from a single USB 3.2 gen 1x2 output (Data limits (I have powered hubs downstream for the FB3s and midi devices)).
This would look like this:
Laptop Out: USB C 3.2 gen 2x1 - 10Gbps (Also known as 3.1 Gen 2)
To
Hub: 5x USB + RJ45 network port (Gigabit)
I am aiming to build a flight case that houses my Midi Controllers, USB DMX and has distribution for sending data to my FB3s, FB4s,
Ideally I would like to be able to just plug the one cable from my laptop into the flight-case.
So I am wondering will the single USB3.2 1x2 be enough, or should I split it out over multiple USBs and the laptops built in RJ45 network port?
Many Thanks
Sol
I'm looking for information on how many FB3s, FB4s and midi devices I can run from a single USB 3.2 gen 1x2 output (Data limits (I have powered hubs downstream for the FB3s and midi devices)).
This would look like this:
Laptop Out: USB C 3.2 gen 2x1 - 10Gbps (Also known as 3.1 Gen 2)
To
Hub: 5x USB + RJ45 network port (Gigabit)
- USB 1: 3x FB3 Via Powered USB Hub.
- USB 2: 4x FB3 Via RE-B3.
- USB 3: APC Mini
- USB 4: APC Mini
- USB 5: ENNTEC DMX USB Pro
- Network port: 1x FB4 + ProDJLink (CDJ Timecode)
I am aiming to build a flight case that houses my Midi Controllers, USB DMX and has distribution for sending data to my FB3s, FB4s,
Ideally I would like to be able to just plug the one cable from my laptop into the flight-case.
So I am wondering will the single USB3.2 1x2 be enough, or should I split it out over multiple USBs and the laptops built in RJ45 network port?
Many Thanks
Sol