the_researcher
Member
Hello!
I've started programming using the Pangolin SDK, using the QM2000 PCI board. Now I'm trying to draw a set of points in a grid fashion. To do that, I draw in vector frame modes. For each point, I use one blanking point before, then two points in the same place to draw the point, and one blanking point after.
in other words, to draw each point, I need to send out 4 points (2 blanking, 2 drawing). The funny thing is, I can only draw 25 points this way (or 100 points actually sent to the board). If I draw more than 25, then I get 25 missing points, and then draws another 25.
Why is it doing that?
I've started programming using the Pangolin SDK, using the QM2000 PCI board. Now I'm trying to draw a set of points in a grid fashion. To do that, I draw in vector frame modes. For each point, I use one blanking point before, then two points in the same place to draw the point, and one blanking point after.
in other words, to draw each point, I need to send out 4 points (2 blanking, 2 drawing). The funny thing is, I can only draw 25 points this way (or 100 points actually sent to the board). If I draw more than 25, then I get 25 missing points, and then draws another 25.
Why is it doing that?