chase between FB3 Quickshow???

[benji.h.blm]

Question, chase between FB3 Quickshow???

is it possible to chase between FB3 dongles?

i can do it in a time line but it would be good to do it like you would with a lighting console.

Say i had 8 x FB3 with 8 x lasers in a circle array i want to be able to make it chase around the circle.

any help would be great

Thanks

 

[Bob@Pangolin]

Thinking of it, You can create a timeline show with quick timeline.
If you configure this correctly, a cue can represent a chase.

However this is limited to the frames you put into quickshow quick timeline..

As far as I know there is no zone chase option in quickshow.

 

[benji.h.blm]

hi bob thanks for the reply

is there a possible update in the near future that will enable the zone chasing?

 

[Bob@Pangolin]

hi bob thanks for the reply

is there a possible update in the near future that will enable the zone chasing?

Sorry, I can't answer that...

 

[-bart-]

It can be done in cues too.

If, for example, you have 4 projectors.
Make 4 projection zones with these projectors assigned to them.
Make 4 separate (identical) cues, assigned to these projection zones.(with cue properties)
Give each cue a color effect, options: By time, Brightness control, Discrete, Speed 25%, Beat control.
Give cue 1, time shift 0%
Give cue 2, time shift 25%
Give cue 3, time shift 50%
Give cue 4, time shift 75%
Select multicue, start all 4 cues.
They probably run out of sync now...
Now make a capture/snapshot by dragging the preview area to an empty cue.
Now if you call the new capture-cue, et voila, a chase over 4 projectors.
(don't move the location of source cues, the links are not dynamic)

See attachment

 

[benji.h.blm]

thanks for the reply -bart-

also thanks for the example

i will give it a go look pretty easy