Hi all,
I am trying to control/trigger a cue exported to my FB4 laser using artnet via an enttec s-play, but having trouble with it.
In order of things I have done:
When the file is exported as an autoplay file cue, it works perfectly fine.
Thanks.
I am trying to control/trigger a cue exported to my FB4 laser using artnet via an enttec s-play, but having trouble with it.
In order of things I have done:
- Exported the cue to my FB4 as a blank DMX FB3 Template (Only need the 16 channels), Page 1 Value 001 for DMX Value range 32-35.
- Created a Artnet/Static cue in the S-Play and patched the following numbers to the correct channels (16 channel mode), note that universe 0 is just s-play universe 1.
- Put the FB4 in artnet mode and configured it as follows:
Universe 0 Channel 1 Profile FB3.
- The S-play and FB4 are both configured correctly i.e same ip address range etc and gateway.
When the file is exported as an autoplay file cue, it works perfectly fine.
Thanks.