zones

So I've recently upgraded from using one FB3 output to now having 4 FB4 outputs. Therefore I now have 4 separate zones to output to. An issue I'm having is that when set a certain cue to output to Scanner mains 1,2,3, and 4 only some of my cues are outputting to all 4 scanners. Others (mostly...

I made a TouchOSC layout for Beyond. It´s a work in progress, with some private logic and stupid jokes and small bugs, but it´s just for learning. Sharing just because sharing is good, if anyone´s interested. The setup is, two faders for two zones, since I´m a video guy who likes layers with...

I saw a thread about this from December, but i'm not sure anything was resolved. I haven't made any mutli-zone cue captures in a while, but when I tried recently, I can't get it to work. The cues are not projecting to the zones i captured. It used to work on previous builds. I don't know if...

I'm trying to figure out a way to make a specific effect... In this video, at approximately 1:08, the great Derek Garbos uses an effect where a cue's brightness sweeps back and forth between projector zones. i'm trying to figure out if this is achieved with a zone chase, or time shifting...

Hi, I´m looking for a way to fade 8 zones up and down via MIDI. One fader for each zone. And also assign clips to zones, which I´ve heard is possible. Can´t start Beyond where I am now, don´t have the FB3 here. So I can´t just figure it out myself either :-/ Side note: Why does Beyond need my...

Hi Everyone, I am new to pangoscript so this one i have tryed to create bud think for me stil to hard to program so i hope some one can help me. for example, i have a rainbow color effect and i can send this to difrent zones but then the zones wil all do the same. i want to have the rainbow...

Hey Everyone, I created a custom workspace and re-created and renamed new zones. However now whenever I turn on the enhanced reality preview or go into my custom universe the content is shown as only graphics. How can I change the appearance to be back to atmospherics/beams? I know theres a...

Hello. I just wonder how I could change the zones viewed in the "Show 9 zones" mode of the preview window? I like it to show no 1, 21,22,23,24,25,26,27 and 28 instead of 1-9. When programming blind (without being connected with a projector) it is terrible difficult to see what is happening when...

Hello, When the command: ResetLiveControl is run, All of the Live Control settings are reset... for the Master Live Control settings. But what if I want to reset all Live Control settings for all zones? Or what if I want to reset all Live Control settings for the selected zones...

Hi Everyone! I'm a Noob. Links are appreciated to my question. I just feel like I've exhausted every youtube video possible to get this answer. I really hate asking questions that seem like there is an easy answer to but I just need help now. I have 2 FB3 units. Can I assign more than...

can some one tell me if there is zone chasing in the Beyond Software?

I continue to have zone issues with Showtime. I get to the venue, fire up showtime, go to settings, zones, establish a safe zone for zone 1, then copy it to zones 2, 4, and 5. However, when I check those zones, it does not copy EXACTLY like I did for zone 1, so I end up doing it for all those...